How do I enable the wheel?
You should have the standard PlayStation®2 gamepad connected to Player 1.
To enable and calibrate the wheel, use the D-pad to make these menu selections:
Select "Options"
Choose "Controller"
Select "Logitech® Driving Force™"
From this point, you can re-configure buttons, calibrate, and set force feedback on or off. The calibration is fairly intuitive. Press X to choose the menu option, then X again when you finish calibrating the particular option.
By default, the right and left paddles on the wheel will be used for shifting if the pedals are attached. If you are not using pedals, by default they will be used for accelerate and brake.
Auto Modellista™ works fine with a hub. Plug the hub into the top USB port and the wheel into the hub, and the game will still automatically detect the wheel.
How can I re-configure the buttons?
You can re-configure any of the buttons in Auto Modellista™. Follow these menu commands to get to the configuration screen:
Select "Options"
Choose "Controller"
Select "Logitech® Driving Force™"
Select "Button Configuration"
How can I calibrate the wheel?
Follow these menu options to get to the calibration screen:
Select "Options"
Choose "Controller"
Select "Logitech® Driving Force™"
Select "Calibration"
Choose "1 Player" (or 2 Player if for Player 2)
How can I adjust force feedback?
Make sure the power cable is plugged into the wheel. Follow these menu commands to toggle force feedback on or off:
Select "Options"
Choose "Controller"
Select "Logitech® Driving Force™"
Choose "Force feedback"
Connect/Disconnect Robustness
The game can be played with both the wheel and the gamepad for the same player at the same time. If you disconnect the wheel during a race, you can use the gamepad.
Using Logitech® GT Force™:
You must have the gamepad connected. Also, you must use the pedal attachment with the Logitech® GT Force™ when you play Auto Modellista™. Use the gamepad to navigate the menus.
Where can I find more information or seek more advice?